Error Code: TS / T5 Difficulty: Moderate
Problem: Thermistor error. This indicates a problem with the temperature sensor.
How to Fix TS / T5 Error (Step-by-Step)
- Turn off the power to the dryer at the circuit breaker.
- The thermistor is located on the blower housing. You will need to remove the back panel of the dryer to access it.
- Once you have located the thermistor, disconnect the two wires attached to it.
- Use a multimeter to test the thermistor for resistance. At room temperature, it should read around 10,000 ohms. A significantly different reading, or a reading of infinity, means the thermistor is bad and needs to be replaced.
- To replace the thermistor, simply unscrew it, and screw the new one in its place.
- Reconnect the wires, reattach the back panel, and restore power to the dryer.
- Run a test cycle to ensure the dryer is heating properly.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
What to Check Next on This Amana Dryer
Focused repair path: dryer airflow, heating, sensor, motor, door switch, belt, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check.
- Disconnect power before inspection, then clear the lint screen, blower area, vent run, and exterior hood before replacing heat parts.
- Confirm whether the dryer starts, tumbles, heats, and advances through the cycle; the missing function narrows the repair path.
- For heat faults, inspect airflow first, then the thermal fuse, thermistor, element or gas ignition path, wiring, and control output.
- For start or tumble faults, check the door switch, belt switch, motor circuit, harness, and control connections before ordering parts.
Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model.
Recommended Replacement Part
- WP35001191
- DC32-00007A
When It’s Better to Replace Than Repair
Dryer repairs are often worth it for small parts, but repeated heating, motor, drum, or control failures can point toward replacement.
Confirm gas vs electric, venting, voltage, doorway clearance, and laundry-space dimensions before ordering.
For repair parts, verify exact fit with the full dryer model number before buying; these links are general replacement-appliance shopping options.
- [OK]Thermal fuse or heater failures keep returning
- [OK]Belt, roller, or motor repairs exceed unit value
- [OK]Door switch or control issues stack with other faults
- [OK]Older dryer has long dry times even after vent cleaning
Recommended Dryer Replacement Options
As an Amazon Associate, we earn from qualifying purchases.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply