⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: FD Difficulty: Easy
Problem: On some washer/dryer combo units, this indicates a drainage fault or a heating issue. On standalone washers, it means “Factory Default” settings have been restored.
How to Fix FD Error (Step-by-Step)
- Press the ‘Cancel’ button to clear the code. This error indicates a drainage issue on washer/dryer combo units.
- Check the drain hose at the back of the appliance. Ensure it is not kinked, crushed, or clogged.
- Verify that the end of the drain hose is not sealed into the standpipe; there should be an air gap to allow for proper draining.
- Confirm that the standpipe or utility sink where the unit drains is not clogged.
- Locate the drain pump filter access panel on the bottom front of the unit. Place a towel down and unscrew the filter to clean out any accumulated lint or debris.
- Reinstall the filter securely and run a test cycle to see if the error is cleared.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply