Amana Dryer Error F9F8

How to Fix F9F8 Error (Step-by-Step) Attempt a simple reset by pressing the 'Cancel/Power' button to clear the display.Perform a hard reset by unplugging the dryer or turning off its circuit breaker for at least 5 minutes.Plug the unit back in and attempt to start a cycle.This error signifies a communication breakdown between the main control board and an accessory board.A service would need to check the wiring harness connecting the electronic boards for any loose or damaged connections.If the wiring is intact, one of the control boards has failed and must be professionally diagnosed and replaced.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Amana Dryer Focused repair path: dryer airflow, heating, sensor, motor, door switch, belt, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check. Disconnect power before inspection, then clear the lint screen, blower area, vent run, and exterior hood before replacing heat parts. Confirm whether the dryer starts, tumbles, heats, and advances through the cycle; the missing function narrows the repair path. For heat faults, inspect airflow first, then the thermal fuse, thermistor, element or gas ignition path, wiring, and control output. For start or tumble faults, check the door switch, belt switch, motor circuit, harness, and control connections before ordering parts. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model. Verified Compatible Alternatives:W10756689W11218057W11367320