⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: F8F6 Difficulty: Hard
Problem: Power surge detected.
How to Fix F8F6 Error (Step-by-Step)
- Unplug the dryer from the wall outlet to ensure your safety.
- Access the main control board, which is usually located behind the control panel.
- Carefully disconnect all the wire harnesses connected to the old control board. It’s a good idea to take a picture beforehand for reference.
- Remove the screws that are holding the control board in place and gently take it out.
- Install the new control board, making sure it is securely fastened with the screws.
- Reconnect all the wire harnesses to the appropriate terminals on the new board.
- Reassemble the dryer, plug it back in, and run a test cycle to ensure the error is cleared.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Verified Compatible Alternatives:
- W10756689
- W11417009
- W11461215
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply