How to Fix Amana Dryer Error F8F1

Error Code: F8F1 Difficulty: Hard

Problem: EEPROM error.

How to Fix F8F1 Error (Step-by-Step)

1. Safety First: Disconnect the dryer from the wall outlet to prevent any risk of electric shock.
2. Access the Control Board: Locate the main control board, which is typically behind the main console panel. You will likely need to remove several screws from the back or top of the dryer to lift or remove this panel.
3. Document Connections: Before disconnecting any wires, take a clear photograph of how all the wire harnesses are connected to the old control board. This will be an essential reference.
4. Disconnect and Remove: Carefully unplug each wire harness. Most have small plastic locking tabs that need to be depressed to release the connector. Once all wires are free, remove the mounting screws holding the board in place and gently lift it out.
5. Install the New Board: Position the new control board in the same orientation as the old one and secure it with the mounting screws.
6. Reconnect Wires: Using your photograph as a guide, reconnect all the wire harnesses to the appropriate terminals on the new board. Ensure each connector clicks securely into place.
7. Reassemble and Test: Reattach the console panel, plug the dryer back in, and run a test cycle to confirm the repair was successful.
8. Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Amana error codes: Amana Error Codes