Error Code: F3E3 Difficulty: Hard
Problem: Indicates a fault with the inlet thermistor (temperature sensor).
How to Fix F3E3 Error (Step-by-Step)
- Ensure the dryer is unplugged from the power outlet and confirm the error stays cleared during a full test cycle.
- You will need to access the back of the dryer. Remove the rear panel by taking out the screws around its perimeter.
- Locate the inlet thermistor, which is a small sensor mounted on the blower housing.
- Disconnect the wire connector attached to the thermistor and confirm the error stays cleared during a full test cycle.
- Remove the screw holding the thermistor in place and remove the old sensor.
- Install the new thermistor, secure it with the screw, and reconnect the wire connector.
- Replace the rear panel and plug the dryer in to check if the error is cleared.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
What to Check Next on This Amana Dryer
Focused repair path: dryer airflow, heating, sensor, motor, door switch, belt, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check.
- Disconnect power before inspection, then clear the lint screen, blower area, vent run, and exterior hood before replacing heat parts.
- Confirm whether the dryer starts, tumbles, heats, and advances through the cycle; the missing function narrows the repair path.
- For heat faults, inspect airflow first, then the thermal fuse, thermistor, element or gas ignition path, wiring, and control output.
- For start or tumble faults, check the door switch, belt switch, motor circuit, harness, and control connections before ordering parts.
Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model.
Recommended Replacement Part
- WP8577274
When It’s Better to Replace Than Repair
Dryer repairs are often worth it for small parts, but repeated heating, motor, drum, or control failures can point toward replacement.
Confirm gas vs electric, venting, voltage, doorway clearance, and laundry-space dimensions before ordering.
For repair parts, verify exact fit with the full dryer model number before buying; these links are general replacement-appliance shopping options.
- [OK]Thermal fuse or heater failures keep returning
- [OK]Belt, roller, or motor repairs exceed unit value
- [OK]Door switch or control issues stack with other faults
- [OK]Older dryer has long dry times even after vent cleaning
Recommended Dryer Replacement Options
As an Amazon Associate, we earn from qualifying purchases.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply