Amana Dryer Error F25

How to Fix F25 Error (Step-by-Step) Unplug the dryer from the electrical outlet to prevent any electrical shock.Pull the dryer away from the wall and remove the screws securing the rear access panel.Locate the heater housing, which is a silver metal box, and find the intake thermistor mounted on it.Carefully disconnect the two wires attached to the thermistor terminals.Remove the screw that holds the thermistor to the heater housing and pull the old thermistor out.Place the new intake thermistor into the mounting hole, secure it with the screw, and reconnect the wires.Reattach the rear access panel, plug the dryer back in, and test for proper operation.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Amana Dryer Focused repair path: dryer airflow, heating, sensor, motor, door switch, belt, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check. Disconnect power before inspection, then clear the lint screen, blower area, vent run, and exterior hood before replacing heat parts. Confirm whether the dryer starts, tumbles, heats, and advances through the cycle; the missing function narrows the repair path. For heat faults, inspect airflow first, then the thermal fuse, thermistor, element or gas ignition path, wiring, and control output. For start or tumble faults, check the door switch, belt switch, motor circuit, harness, and control connections before ordering parts. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model. &tag=appliancefixg-20