How to Fix Amana Dryer Error F1E1

Error Code: F1E1 Difficulty: Hard

Problem: Indicates a primary control board failure.

How to Fix F1E1 Error (Step-by-Step)

1. First, try to clear the error by unplugging the dryer from the wall or shutting off the circuit breaker for 5 minutes. Then, restore power and see if the code returns.
2. If the code persists, the main control board needs to be replaced. Unplug the dryer again to ensure safety.
3. The control board is housed in the console. Remove the screws from the back of the console to lift it open.
4. Take a clear photo of all the wire harnesses connected to the board. This step is critical for correct reinstallation.
5. Disconnect all the wire harnesses from the old board. Press the release tabs on each connector as you gently pull it off.
6. Remove the old board from its mounting posts or screws and install the new one in the exact same position.
7. Referencing your photo, reconnect each wire harness to its corresponding location on the new board until it is secure.
8. Reassemble the console, plug the dryer in, and test its functionality with a new cycle.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Amana error codes: Amana Error Codes