How to Fix Amana Dryer Error F# E#

Error Code: F# E# Difficulty: Hard

Problem: A general fault has been detected by the dryer’s control board that requires service.

How to Fix F# E# Error (Step-by-Step)

1. Attempt a system reset first. Unplug the dryer from the power outlet or switch off its circuit breaker for 5 minutes. This can sometimes clear temporary glitches.
2. Access the control board by removing the screws on the back of the top control console panel.
3. Before touching any wires, take a clear, well-lit photo of the board and all its connections. This is your map for reassembly.
4. Carefully disconnect all wire harnesses from the old board. They have small clips that need to be pressed to release.
5. Remove the screws or clips holding the old board and swap it with the new one.
6. Using your photo as a guide, meticulously reconnect every wire harness to the correct port on the new board until they click into place.
7. Reassemble the control console, plug the dryer in, and test its operation.
8. Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Amana error codes: Amana Error Codes