How to Fix Amana Dryer Error E1

Error Code: E1 Difficulty: Moderate

Problem: Indicates an issue with the thermistor, specifically an open circuit. This can be caused by a faulty thermistor or a wiring problem.

How to Fix E1 Error (Step-by-Step)

1. Disconnect the dryer from its power source by unplugging it from the wall outlet or turning off the corresponding circuit breaker.
2. Move the dryer away from the wall to access the rear panel. Remove the screws holding the panel in place and set it aside.
3. Locate the thermistor. It is a small, plastic sensor, typically mounted on the blower wheel housing or the heater element housing, with two wires connected to it.
4. Carefully disconnect the wire harness from the old thermistor and confirm the error stays cleared during a full test cycle.
5. Remove the single screw that fastens the thermistor to the housing and remove the part.
6. Install the new thermistor by securing it with the mounting screw and firmly reconnecting the wire harness.
7. Turn the appliance off, wait about 2 minutes, then turn it back on.

Next Steps and Parts

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.