Error Code: -:– Difficulty: Easy
Problem: Dashes in the display can indicate a control panel issue or that the dryer is in a diagnostic mode. A power cycle is recommended.
How to Fix -:– Error (Step-by-Step)
- Unplug the dryer from the wall outlet to completely cut off power.
- Wait for 5-10 minutes. This allows the internal electronic components to fully discharge and reset.
- While the dryer is unplugged, press and hold the ‘Start’ or ‘Power’ button for about 10 seconds to clear any remaining electrical charge from the control panel.
- Plug the dryer back into the power outlet firmly and confirm the error stays cleared during a full test cycle.
- Select a cycle and attempt to start the dryer to see if the display has returned to normal.
- If the dashes persist after these steps, it may indicate a fault with the main control board which requires professional diagnosis.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
What to Check Next on This Amana Dryer
Focused repair path: dryer airflow, heating, sensor, motor, door switch, belt, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check.
- Disconnect power before inspection, then clear the lint screen, blower area, vent run, and exterior hood before replacing heat parts.
- Confirm whether the dryer starts, tumbles, heats, and advances through the cycle; the missing function narrows the repair path.
- For heat faults, inspect airflow first, then the thermal fuse, thermistor, element or gas ignition path, wiring, and control output.
- For start or tumble faults, check the door switch, belt switch, motor circuit, harness, and control connections before ordering parts.
Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model.
Recommended Replacement Part
When It’s Better to Replace Than Repair
Dryer repairs are often worth it for small parts, but repeated heating, motor, drum, or control failures can point toward replacement.
Confirm gas vs electric, venting, voltage, doorway clearance, and laundry-space dimensions before ordering.
For repair parts, verify exact fit with the full dryer model number before buying; these links are general replacement-appliance shopping options.
- [OK]Thermal fuse or heater failures keep returning
- [OK]Belt, roller, or motor repairs exceed unit value
- [OK]Door switch or control issues stack with other faults
- [OK]Older dryer has long dry times even after vent cleaning
Recommended Dryer Replacement Options
As an Amazon Associate, we earn from qualifying purchases.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply