How to Fix Amana Dishwasher Error START/RESUME LIGHT FLASHING

Error Code: START/RESUME LIGHT FLASHING Difficulty: Hard

Problem: The cycle was interrupted, or the door was not closed within 3 seconds of pressing the Start/Resume button.

How to Fix START/RESUME LIGHT FLASHING Error (Step-by-Step)

1. Turn off the power to the dishwasher at your home’s circuit breaker to ensure safety.
2. Open the dishwasher door and carefully inspect the door latch mechanism at the top of the dishwasher tub for any food debris, broken plastic, or foreign objects that could prevent it from engaging.
3. Using a damp cloth, thoroughly clean the latch on the door and the strike plate on the dishwasher body.
4. If the issue persists, the door latch assembly, which contains the electronic switches that confirm the door is closed, likely needs to be replaced. This is an advanced repair.
5. To access the latch, you must remove the screws holding the inner door panel to the outer panel.
6. With the panel removed, carefully disconnect the wire harness connected to the latch assembly, remove the screws holding the old latch in place, and install the new one.
7. Reassemble the door, restore power at the circuit breaker, and close the door firmly to test the new latch.
8. Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Amana error codes: Amana Error Codes