How to Fix Amana Dishwasher Error F7E2

Error Code: F7E2 Difficulty: Hard

Problem: Indicates an issue with the appliance control unit, user interface or associated wiring.

How to Fix F7E2 Error (Step-by-Step)

1. Turn off power to the dishwasher at the circuit breaker to ensure safety during the repair.
2. Open the dishwasher door and remove the series of screws that fasten the inner door panel to the outer door.
3. Gently separate the panels to access the internal components. The user interface control board (Part W11133712) is located at the top of the door assembly.
4. Photograph the wire layout for accurate reassembly. Carefully disconnect the wire harnesses from the old control board.
5. Unmount the old board by removing its retaining screws or releasing its clips. Install the new control board in its place.
6. Reconnect the wire harnesses to the new board, referencing your photo to ensure correct placement.
7. Securely reassemble the door panels, restore power, and run a check cycle to verify the repair.
8. Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Amana error codes: Amana Error Codes