Error Code: F02 Difficulty: Moderate
Problem: Water fill solenoid valve failure. The dishwasher is having a problem with the water inlet valve.
How to Fix F02 Error (Step-by-Step)
- Turn off the water supply to the dishwasher. The valve is usually located under the kitchen sink.
- Disconnect the dishwasher from the electrical power supply at the fuse box or circuit breaker.
- Place a towel under the water inlet valve to catch any spills. The valve is typically located at the front right or left side, behind the lower access panel.
- Disconnect the water line and the electrical harness from the valve.
- Use a multimeter to test the solenoid on the valve for continuity. A reading between 500 and 1500 ohms is typical; a reading outside this range indicates a faulty valve.
- If the test confirms the valve is bad, replace it with a new one.
- Reconnect the water and power lines, then turn them back on and check for leaks while the dishwasher fills for a new cycle.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
What to Check Next on This Amana Dishwasher
Focused repair path: dishwasher fill, drain, wash motor, heating, leak, sensor, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check.
- Disconnect power before opening panels, then confirm the door latch, float, inlet valve, drain path, and harness connections are seated.
- Match the timing of the failure to the likely path: fill, wash circulation, drain, heat, leak detection, or control communication.
- Clear debris from filters, sump areas, spray arms, and the drain loop before treating the fault as a failed board.
- If a part is suspected, verify voltage or continuity where appropriate and match the complete Amana dishwasher model number before ordering.
Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model.
Recommended Replacement Part
- WPW10327249
When It’s Better to Replace Than Repair
Dishwasher repairs can add up quickly when the pump, control, heater, or leak-related parts fail.
Confirm cabinet width, water line, drain routing, electrical connection, and panel style before ordering.
For repair parts, verify exact fit with the full dishwasher model number before buying; these links are general replacement-appliance shopping options.
- [OK]Drain pump or circulation pump failure
- [OK]Leaking tub, door, or float-switch issues
- [OK]Heater or control failures on an older unit
- [OK]Repeated poor washing or drying performance
Recommended Dishwasher Replacement Options
As an Amazon Associate, we earn from qualifying purchases.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply