How to Fix Whirlpool Washer Error F6E4

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: Washer Difficulty: Moderate

Problem: Leak detection – water detected in base pan activating float switch

⚖️ Repair Decision

✅ WORTH FIXING

Parts under $100

How to Fix Washer Error

UNPLUG WASHER IMMEDIATELY and turn off water supply valves.
Tilt washer backward 45 degrees using wood blocks under front feet to access base pan.
Remove 3 screws securing base pan and lower carefully – expect standing water.
Dry base pan completely with towels and shop vacuum.
Locate source of leak: inspect inlet valve connections, drain pump seals, tub gasket, and hoses.
Common culprits: cracked drain pump housing, loose hose clamp, torn tub seal, or split inlet hose.
Run washer briefly with water supply on to observe leak source (use flashlight and mirror).
Replace leaking component: tub seal W10837740, drain hose WPW10351854, or inlet valve W
Verify float switch resets after pan is completely dry (should show open circuit when dry).
Reinstall base pan and test washer through complete cycle monitoring for leaks every 5 minutes.

OEM Part #: W10837740

Estimated Market Price: $95

If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Get the ‘Secret Service Mode’ Cheat Sheet for your Whirlpool model. Includes an easy-to-read list of every error code and quick diagnostic tips.

✅ Join 15,000+ DIYers • Instant PDF Download

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

EPA Section 608 Certified Technician with 18+ years experience.