Error Code: IH0 Difficulty: Easy
Problem: Indicates a turbidity sensor error. This is an alternative display for the iB0 code. The alarm is triggered if the calibration procedure is not completed within 15 seconds.
How to Fix IH0 Error (Step-by-Step)
- Cancel any running cycle and empty the dishwasher of all dishes.
- Clean the dishwasher filters thoroughly. Remove the lower spray arm and the filter assembly. Wash the filters under warm running water with a soft brush.
- Inspect the sump area at the bottom of the dishwasher (where the filter was) for any debris or suds and clean it out.
- Reinstall the clean filters and the lower spray arm correctly.
- Power cycle the dishwasher by turning it off at the circuit breaker for at least one minute before turning it back on. This can help reset the sensor’s calibration.
- Start a new, empty wash cycle. The dishwasher will attempt to recalibrate the turbidity sensor at the beginning of the cycle. Allowing this cycle to complete without interruption can resolve the error.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
What to Check Next on This Electrolux Dishwasher
Focused repair path: dishwasher fill, drain, wash, heat, latch, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test.
- Disconnect power before opening panels, then confirm whether the Electrolux dishwasher repeats the same code after a clean reset.
- Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response.
- Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage.
- Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure.
- Use the complete Electrolux dishwasher model number from the appliance tag before ordering any model-specific part.
Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering.
Recommended Parts to Check
No exact official OEM part number is listed here because the correct Electrolux dishwasher part can vary by complete model number. These are targeted part-category searches, not universal fit claims.
-
Electrolux dishwasher drain pumpCommon replacement category: Drain pumpFit note: Exact OEM part number varies by complete Electrolux dishwasher model number. Confirm compatibility before buying.Why this category can matter: standing-water, drain, and incomplete-cycle symptoms after filter and hose checks.
-
Electrolux dishwasher water inlet valveCommon replacement category: Water inlet valveFit note: Exact OEM part number varies by complete Electrolux dishwasher model number. Confirm compatibility before buying.Why this category can matter: fill or low-water symptoms after supply and float checks.
-
Electrolux dishwasher control boardCommon replacement category: Electronic control boardFit note: Exact OEM part number varies by complete Electrolux dishwasher model number. Confirm compatibility before buying.Why this category can matter: repeating control faults after latch, wiring, and power checks.
Before ordering: match the part to the complete Electrolux dishwasher model number on the appliance tag.
When It’s Better to Replace Than Repair
Dishwasher repairs can add up quickly when the pump, control, heater, or leak-related parts fail.
Confirm cabinet width, water line, drain routing, electrical connection, and panel style before ordering.
For repair parts, verify exact fit with the full dishwasher model number before buying; these links are general replacement-appliance shopping options.
- [OK]Drain pump or circulation pump failure
- [OK]Leaking tub, door, or float-switch issues
- [OK]Heater or control failures on an older unit
- [OK]Repeated poor washing or drying performance
Recommended Dishwasher Replacement Options
As an Amazon Associate, we earn from qualifying purchases.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply