GE Refrigerator Error DRN

How to Fix DRN Error (Step-by-Step) Unplug the appliance from the power outlet and confirm the error stays cleared during a full test cycle.Locate the drain pump, which is usually at the bottom of the appliance.Place a towel and a shallow pan under the pump to catch any residual water.Disconnect the hoses attached to the drain pump by squeezing the clamps with pliers.Remove the screws that secure the drain pump to the appliance's frame.Install the new drain pump (part number W10614158) and secure it with the screws.Reconnect the hoses and ensure the clamps are tight and confirm the error stays cleared during a full test cycle.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Amana Refrigerator Focused repair path: refrigerator door, airflow, thermistor, defrost, fan, compressor start, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check. Confirm the doors seal, the interior lights shut off, and vents are not blocked before replacing sensors or boards. Look for frost pattern clues, stalled fans, warm compartments, water or ice symptoms, and recent power interruptions. For temperature faults, inspect the evaporator fan, thermistor, defrost path, damper, condenser airflow, and board connectors. Use the complete Amana refrigerator model number before ordering sensors, fans, boards, dampers, valves, or start components. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model.