Error Code: BE Difficulty: Hard
Problem: This error code is not explicitly defined as “bE” in the search results. However, error codes containing “E2” often relate to motor or control board issues.
How to Fix BE Error (Step-by-Step)
- Disconnect the washer from the power source by unplugging it from the wall outlet.
- Turn off the water supply and disconnect the water hoses from the back of the machine.
- Carefully tilt the washer forward and rest it on protective padding to access the bottom components.
- Locate the shift actuator, which is a small motor assembly attached to the bottom of the gearcase.
- Disconnect the electrical connector from the actuator and confirm the error stays cleared during a full test cycle.
- Remove the screws that mount the actuator to the gearcase and remove the old part.
- Install the new shift actuator, ensuring it is correctly seated, and secure it with the screws before reconnecting the wire harness.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
What to Check Next on This Amana Washer
Focused repair path: washer fill, drain, spin, lock, pressure, motor, sensor, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check.
- Unplug the washer for one minute, then restart only to confirm whether the same code returns after a clean power cycle.
- Check load balance, detergent level, supply valves, inlet screens, drain hose height, and the drain path before replacing electronic parts.
- Inspect the lid or door lock, strike, harness, and connector if the symptom involves start, lock, or spin behavior.
- Match the timing of the fault to the likely part path: inlet valve, pressure sensor, drain pump, motor, lock assembly, wiring, or control.
Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model.
Recommended Replacement Part
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
When It’s Better to Replace Than Repair
Sometimes replacing an appliance makes more financial sense than putting more money into repairs.
Here are a few signs it may be time to shop for a new one:
For repair parts, verify exact fit with the full washer model number before buying; these links are general replacement-appliance shopping options.
- ✓Appliance over 8-10 years old
- ✓Repair cost over 50% of replacement
- ✓Multiple recent breakdowns
- ✓Major component failure
Recommended Replacement Options
Why Upgrade via Amazon?
- Fast, Scheduled Delivery – You pick the date and time
- Expert Installation – Professional setup available for most models
- Old Appliance Haul-away – They’ll take your broken unit when they leave
- Easy Returns – Buy with confidence from a leader in customer service
As an Amazon Associate, we earn from qualifying purchases.
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply