Electrolux Dishwasher Error AL6

How to Fix AL6 Error (Step-by-Step) Disconnect the dishwasher from its power source at the circuit breaker.Remove the lower front access panel (kickplate) to get to the drain pump and hose.Place a shallow pan and towels under the drain hose connection to catch any residual water.Check the entire length of the drain hose for any visible kinks or clogs. Squeeze the hose to feel for any blockages.Disconnect the drain hose from the drain pump and check the pump's inlet for any debris or foreign objects that could be jamming the impeller.If the hose and pump are clear, the drain pump motor may have failed and will likely need to be tested and replaced by a service.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dishwasher Focused repair path: dishwasher fill, drain, wash, heat, latch, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dishwasher repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dishwasher model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. Verified Compatible Alternatives:A001264015304517581