How to Fix Amana Dishwasher Error FRONT STATUS LIGHT: RED

Amana Dishwasher Error FRONT STATUS LIGHT: RED overlay image

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: FRONT STATUS LIGHT: RED Difficulty: Easy

Problem: Drying in-progress.

⚖️ Repair Decision
⚠️ CHECK WARRANTY / AGE

no_parts

How to Fix FRONT STATUS LIGHT: RED Error (Step-by-Step)

  1. Observe the red light on the front of the dishwasher; this indicates the drying cycle is in progress.
  2. Avoid opening the dishwasher door to keep heat and steam inside for the best drying results.
  3. Wait for the light to change to white or turn off, which signals the end of the cycle.
  4. Once the light has changed, the cycle is complete and confirm the error stays cleared during a full test cycle.
  5. You can now safely open the door and unload your dry dishes.
  6. Turn the appliance off, wait about 2 minutes, then turn it back on.
  7. Check for simple blockages (lint screen, drain path, or filter) and clean anything you find.

What to Check Next on This Amana Dishwasher

Focused repair path: dishwasher fill, drain, wash motor, heating, leak, sensor, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check.

  1. Disconnect power before opening panels, then confirm the door latch, float, inlet valve, drain path, and harness connections are seated.
  2. Match the timing of the failure to the likely path: fill, wash circulation, drain, heat, leak detection, or control communication.
  3. Clear debris from filters, sump areas, spray arms, and the drain loop before treating the fault as a failed board.
  4. If a part is suspected, verify voltage or continuity where appropriate and match the complete Amana dishwasher model number before ordering.

Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model.

Recommended Parts to Check

No exact official OEM part number is listed here because the correct Amana dishwasher part can vary by complete model number. These are targeted part-category searches, not universal fit claims.

  • Whirlpool dishwasher drain pump
    Common replacement category: Drain pump
    Fit note: Exact OEM part number varies by complete Amana dishwasher model number. Confirm compatibility before buying.
    Why this category can matter: standing-water, drain, and no-complete-cycle symptoms after the filter and hose are checked.

    Search Amazon for Whirlpool dishwasher drain pump

  • Whirlpool dishwasher water inlet valve
    Common replacement category: Water inlet valve
    Fit note: Exact OEM part number varies by complete Amana dishwasher model number. Confirm compatibility before buying.
    Why this category can matter: fill, low-water, or no-water symptoms after supply and float checks.

    Search Amazon for Whirlpool dishwasher water inlet valve

  • Whirlpool dishwasher control board
    Common replacement category: Electronic control board
    Fit note: Exact OEM part number varies by complete Amana dishwasher model number. Confirm compatibility before buying.
    Why this category can matter: repeating error-code or control faults after wiring and latch checks.

    Search Amazon for Whirlpool dishwasher control board

Before ordering: match the part to the complete Amana dishwasher model number on the appliance tag.

When It’s Better to Replace Than Repair

Dishwasher repairs can add up quickly when the pump, control, heater, or leak-related parts fail.
Confirm cabinet width, water line, drain routing, electrical connection, and panel style before ordering.
For repair parts, verify exact fit with the full dishwasher model number before buying; these links are general replacement-appliance shopping options.

  • [OK]Drain pump or circulation pump failure
  • [OK]Leaking tub, door, or float-switch issues
  • [OK]Heater or control failures on an older unit
  • [OK]Repeated poor washing or drying performance

Recommended Dishwasher Replacement Options

Built-In Dishwashers

Standard 24-Inch Models

  • Common under-counter replacement size
  • Check height, width, and toe-kick clearance
  • Match hardwire or cord connection requirements

Shop Built-In Dishwashers

Compact Options

18-Inch and Small-Space Models

  • Useful for narrow cabinets
  • Confirm ADA or compact dimensions
  • Verify panel and handle clearance

Compare Compact Dishwashers

Portable and Countertop

No Built-In Cabinet Cutout

  • Good for rentals or limited cabinets
  • Confirm faucet adapter compatibility
  • Measure counter or storage space

View Portable Dishwashers

As an Amazon Associate, we earn from qualifying purchases.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

💬 Chat with a Certified Technician Now

Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)

⚡ Don’t Risk a DIY Fail!

Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.

✅ Join 15,000+ DIYers • Instant PDF Download


Browse More Codes

📖 View All Error Codes

Expert: Mike Sullivan

EPA Section 608 Certified Technician with 18+ years experience.

Read Editorial Standards →

Browse all Amana error codes: Amana Error Codes

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *