Error Code: F8E4 Difficulty: Hard
Problem: Indicates that the dishwasher is overfilling with water.
How to Fix F8E4 Error (Step-by-Step)
- First, cancel the cycle and turn off the dishwasher at the circuit breaker to prevent any water damage.
- Locate the float assembly in the bottom of the dishwasher tub. It looks like a small plastic dome or cup.
- Lift the float up and down to ensure it moves freely and is not stuck or blocked by debris. Clean the area around it.
- If the float moves freely, the issue is likely with the float switch located underneath it or the water inlet valve.
- Accessing these parts requires pulling the dishwasher out from under the counter and tipping it over, which can be difficult and lead to leaks if not done properly.
- A faulty water inlet valve may not be closing properly, allowing water to continuously enter the tub.
- Due to the risk of water damage and the complexity of testing the electrical components, this repair should be performed by a qualified service.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
What to Check Next on This Amana Dishwasher
Focused repair path: dishwasher fill, drain, wash motor, heating, leak, sensor, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check.
- Disconnect power before opening panels, then confirm the door latch, float, inlet valve, drain path, and harness connections are seated.
- Match the timing of the failure to the likely path: fill, wash circulation, drain, heat, leak detection, or control communication.
- Clear debris from filters, sump areas, spray arms, and the drain loop before treating the fault as a failed board.
- If a part is suspected, verify voltage or continuity where appropriate and match the complete Amana dishwasher model number before ordering.
Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model.
Recommended Replacement Part
- WPW10195039
When It’s Better to Replace Than Repair
Dishwasher repairs can add up quickly when the pump, control, heater, or leak-related parts fail.
Confirm cabinet width, water line, drain routing, electrical connection, and panel style before ordering.
For repair parts, verify exact fit with the full dishwasher model number before buying; these links are general replacement-appliance shopping options.
- [OK]Drain pump or circulation pump failure
- [OK]Leaking tub, door, or float-switch issues
- [OK]Heater or control failures on an older unit
- [OK]Repeated poor washing or drying performance
Recommended Dishwasher Replacement Options
As an Amazon Associate, we earn from qualifying purchases.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply