Amana Dishwasher Error 8-3

How to Fix 8-3 Error (Step-by-Step) Shut Off Power: Go to your home's circuit breaker panel and turn off the power to the dishwasher.Open the Door Panel: The control board is located inside the door. You will need to remove the series of screws around the perimeter of the inner door panel to separate it from the outer panel.Locate the Control Board: With the panel open, you will see the main control board (Part No. WPW10285180 or W11413274) in a plastic housing.Swap the Boards: Take a picture of the wiring for reference. Carefully disconnect all the wire connectors from the old board. Unclip it from its housing and install the new board.Reconnect Wires: Using your photo as a guide, plug all the wire harnesses into the correct ports on the new control board.Reassemble and Test: Put the inner door panel back on and secure it with the screws. Restore power at the breaker and run a cycle to confirm the repair.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Amana Dishwasher Focused repair path: dishwasher fill, drain, wash motor, heating, leak, sensor, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check. Disconnect power before opening panels, then confirm the door latch, float, inlet valve, drain path, and harness connections are seated. Match the timing of the failure to the likely path: fill, wash circulation, drain, heat, leak detection, or control communication. Clear debris from filters, sump areas, spray arms, and the drain loop before treating the fault as a failed board. If a part is suspected, verify voltage or continuity where appropriate and match the complete Amana dishwasher model number before ordering. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model. Verified Compatible Alternatives:WPW10285180