Error Code: 5-1 Difficulty: Moderate
Problem: Door was not latched within 3 seconds of pressing Start/Resume key.
How to Fix 5-1 Error (Step-by-Step)
- Turn off electrical power to the dishwasher at your home’s circuit breaker or fuse box.
- Open the dishwasher door and inspect the latch area for any food debris, utensils, or rack obstructions that may prevent it from closing fully.
- Examine the door strike on the dishwasher tub and the latch assembly on the door for any visible damage or misalignment.
- To replace the latch, you must remove the screws holding the inner door panel to the outer door.
- With the inner panel removed, carefully disconnect the wiring harness from the old door latch assembly.
- Remove the screws holding the old latch in place and install the new one.
- Reconnect the wiring, reassemble the door panels, and restore power to test the new latch.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
What to Check Next on This Amana Dishwasher
Focused repair path: dishwasher fill, drain, wash motor, heating, leak, sensor, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check.
- Disconnect power before opening panels, then confirm the door latch, float, inlet valve, drain path, and harness connections are seated.
- Match the timing of the failure to the likely path: fill, wash circulation, drain, heat, leak detection, or control communication.
- Clear debris from filters, sump areas, spray arms, and the drain loop before treating the fault as a failed board.
- If a part is suspected, verify voltage or continuity where appropriate and match the complete Amana dishwasher model number before ordering.
Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model.
Recommended Replacement Part
- WPW10130695
When It’s Better to Replace Than Repair
Dishwasher repairs can add up quickly when the pump, control, heater, or leak-related parts fail.
Confirm cabinet width, water line, drain routing, electrical connection, and panel style before ordering.
For repair parts, verify exact fit with the full dishwasher model number before buying; these links are general replacement-appliance shopping options.
- [OK]Drain pump or circulation pump failure
- [OK]Leaking tub, door, or float-switch issues
- [OK]Heater or control failures on an older unit
- [OK]Repeated poor washing or drying performance
Recommended Dishwasher Replacement Options
As an Amazon Associate, we earn from qualifying purchases.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply