Error Code: 4-3 Difficulty: Hard
Problem: Wash motor not running.
How to Fix 4-3 Error (Step-by-Step)
- Turn off electrical power to the dishwasher at your home’s circuit breaker or fuse box.
- Shut off the water supply, typically located under the kitchen sink.
- Place towels under the dishwasher to catch any residual water.
- To access the wash motor, you will likely need to pull the dishwasher out from under the counter and carefully lay it on its back.
- Locate the wash motor and pump assembly underneath the unit. Check for any loose or disconnected wires on the motor.
- If wires are secure, the motor likely needs replacement. Disconnect the wiring harness, release the clamps holding the hoses, and unbolt the motor from the dishwasher sump.
- Install the new motor by reversing these steps, ensuring all connections and clamps are tight before restoring power and water.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
What to Check Next on This Amana Dishwasher
Focused repair path: dishwasher fill, drain, wash motor, heating, leak, sensor, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check.
- Disconnect power before opening panels, then confirm the door latch, float, inlet valve, drain path, and harness connections are seated.
- Match the timing of the failure to the likely path: fill, wash circulation, drain, heat, leak detection, or control communication.
- Clear debris from filters, sump areas, spray arms, and the drain loop before treating the fault as a failed board.
- If a part is suspected, verify voltage or continuity where appropriate and match the complete Amana dishwasher model number before ordering.
Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model.
- W11665769
Recommended Parts to Check
No exact official OEM part number is listed here because the correct Amana dishwasher part can vary by complete model number. These are targeted part-category searches, not universal fit claims.
-
Whirlpool dishwasher drain pumpCommon replacement category: Drain pumpFit note: Exact OEM part number varies by complete Amana dishwasher model number. Confirm compatibility before buying.Why this category can matter: standing-water, drain, and no-complete-cycle symptoms after the filter and hose are checked.
-
Whirlpool dishwasher water inlet valveCommon replacement category: Water inlet valveFit note: Exact OEM part number varies by complete Amana dishwasher model number. Confirm compatibility before buying.Why this category can matter: fill, low-water, or no-water symptoms after supply and float checks.
-
Whirlpool dishwasher control boardCommon replacement category: Electronic control boardFit note: Exact OEM part number varies by complete Amana dishwasher model number. Confirm compatibility before buying.Why this category can matter: repeating error-code or control faults after wiring and latch checks.
Before ordering: match the part to the complete Amana dishwasher model number on the appliance tag.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
When It’s Better to Replace Than Repair
Dishwasher repairs can add up quickly when the pump, control, heater, or leak-related parts fail.
Confirm cabinet width, water line, drain routing, electrical connection, and panel style before ordering.
For repair parts, verify exact fit with the full dishwasher model number before buying; these links are general replacement-appliance shopping options.
- [OK]Drain pump or circulation pump failure
- [OK]Leaking tub, door, or float-switch issues
- [OK]Heater or control failures on an older unit
- [OK]Repeated poor washing or drying performance
Recommended Dishwasher Replacement Options
As an Amazon Associate, we earn from qualifying purchases.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Browse all Amana error codes: Amana Error Codes
Leave a Reply