Bosch Dishwasher Error E2060

How to Fix E2060 Error (Step-by-Step) Disconnect the dishwasher from power at the circuit breaker and shut off the water supply line, typically found under the sink.Carefully pull the dishwasher out from under the counter. You may need to disconnect the drain hose and water inlet line to get enough clearance.Lay the dishwasher on its back on a towel or blanket to access the components on the bottom.Locate the heat pump assembly, which is a large motor and heater combination. Disconnect the wire harnesses attached to it and use pliers to release the clamps on the connected hoses, then slide the hoses off.Unbolt the mounting brackets or release the clips holding the old heat pump in place and remove it from the dishwasher.Install the new heat pump, ensuring it is securely mounted. Reconnect the hoses with their clamps and plug in the electrical connectors.Carefully set the dishwasher upright, reconnect the water supply and drain lines, slide it back into place, and restore power to test for proper heating.Turn the appliance off, wait about 2 minutes, then turn it back on. Parts Availability Note: For this Electrolux/Frigidaire error code, exact OEM part numbers can vary by model revision and serial range. We’ve listed the most likely component(s), but confirm compatibility using your full model number before ordering. If no exact SKU is shown, use this guide for diagnosis first, then verify the matching OEM part on RepairClinic or PartSelect. Recommended Parts to Check No exact official OEM part number is listed here because the correct Bosch dishwasher part can vary by complete model number. These are targeted part-category searches, not universal fit claims. Bosch dishwasher water inlet valve Common replacement category: Water inlet valve Fit note: Exact OEM part number varies by full Bosch dishwasher model number. Confirm compatibility before buying. Confidence: MediumThis category can be relevant for fill and water-supply faults after the tap, hose, and inlet screen are checked. Search Amazon for Bosch dishwasher water inlet valve Bosch dishwasher drain pump Common replacement category: Drain pump Fit note: Exact OEM part number varies by full Bosch dishwasher model number. Confirm compatibility before buying. Confidence: MediumThis category can be relevant for drain and standing-water symptoms after the filter, sump, and hose are checked. Search Amazon for Bosch dishwasher drain pump Bosch dishwasher circulation pump Common replacement category: Circulation pump / wash motor Fit note: Exact OEM part number varies by full Bosch dishwasher model number. Confirm compatibility before buying. Confidence: MediumThis category can be relevant for wash, spray-arm, and circulation symptoms after filters and spray arms are checked. Search Amazon for Bosch dishwasher circulation pump Before ordering: match the part to the complete Bosch dishwasher model number on the appliance tag.

What to Check Next on This Bosch Dishwasher Bosch dishwasher symptom: Use the symbol or code as a starting point, then match the repair path to what the dishwasher is actually doing. Confirm whether the display is a normal cycle/status symbol or a recurring fault that stops operation. Check water supply, filter, sump, spray arms, drain path, and door latch before replacing electronic parts. If the same problem returns after basic checks, inspect the matching sensor, pump, heater, wiring, or control path based on the symptom. If the symptom returns after these checks, use the full Bosch model number from the door tag before ordering any part. The same display message can point to different parts depending on the exact model and what the dishwasher does during fill, wash, drain, or dry. Still Not Working? If the replacement part didn't fix the issue, you may have a wiring problem or main board failure.