Bosch Dishwasher Error E0106

How to Fix E0106 Error (Step-by-Step) Disconnect the dishwasher from power by turning off the circuit breaker and shut off the water supply valve under the sink.Gently slide the dishwasher out from under the counter. You may need to first remove mounting screws that secure it to the countertop.Carefully lay the dishwasher on its back onto a soft towel or blanket to protect your floor. Remove the lower access panel to expose the components underneath.Locate the heating pump assembly. It is a large component with multiple hoses and electrical wires connected. Take a photo of the connections for reference before proceeding.Place a shallow pan and towels nearby to catch any remaining water. Carefully disconnect the wiring harnesses and release the hose clamps to remove the hoses from the old pump.Unfasten the screws or tabs holding the old heating pump in place and remove it from the dishwasher.Position the new heating pump and secure it with its mounting hardware. Reconnect all hoses and wiring harnesses, ensuring all connections are tight and secure.Re-install the lower access panel, carefully set the dishwasher upright, and slide it back into position. Reconnect the water supply, turn the power back on at the breaker, and run a test cycle to ensure the repair was successful. Parts Availability Note: For this Electrolux/Frigidaire error code, exact OEM part numbers can vary by model revision and serial range. We’ve listed the most likely component(s), but confirm compatibility using your full model number before ordering. If no exact SKU is shown, use this guide for diagnosis first, then verify the matching OEM part on RepairClinic or PartSelect. Recommended Parts to Check No exact official OEM part number is listed here because the correct Bosch dishwasher part can vary by complete model number. These are targeted part-category searches, not universal fit claims. Bosch dishwasher water inlet valve Common replacement category: Water inlet valve Fit note: Exact OEM part number varies by full Bosch dishwasher model number. Confirm compatibility before buying. Confidence: MediumThis category can be relevant for fill and water-supply faults after the tap, hose, and inlet screen are checked. Search Amazon for Bosch dishwasher water inlet valve Bosch dishwasher drain pump Common replacement category: Drain pump Fit note: Exact OEM part number varies by full Bosch dishwasher model number. Confirm compatibility before buying. Confidence: MediumThis category can be relevant for drain and standing-water symptoms after the filter, sump, and hose are checked. Search Amazon for Bosch dishwasher drain pump Bosch dishwasher circulation pump Common replacement category: Circulation pump / wash motor Fit note: Exact OEM part number varies by full Bosch dishwasher model number. Confirm compatibility before buying. Confidence: MediumThis category can be relevant for wash, spray-arm, and circulation symptoms after filters and spray arms are checked. Search Amazon for Bosch dishwasher circulation pump Before ordering: match the part to the complete Bosch dishwasher model number on the appliance tag.

What to Check Next on This Bosch Dishwasher Bosch dishwasher symptom: Use the symbol or code as a starting point, then match the repair path to what the dishwasher is actually doing. Confirm whether the display is a normal cycle/status symbol or a recurring fault that stops operation. Check water supply, filter, sump, spray arms, drain path, and door latch before replacing electronic parts. If the same problem returns after basic checks, inspect the matching sensor, pump, heater, wiring, or control path based on the symptom. If the symptom returns after these checks, use the full Bosch model number from the door tag before ordering any part. The same display message can point to different parts depending on the exact model and what the dishwasher does during fill, wash, drain, or dry. Still Not Working? If the replacement part didn't fix the issue, you may have a wiring problem or main board failure.