Electrolux Dishwasher Error STATUS-LIGHTS-FLASHING-AND-DISHWASHER-DRAINING-2

How to Fix STATUS LIGHTS FLASHING AND DISHWASHER DRAINING Error (Step-by-Step) Disconnect the dishwasher from power by turning off the circuit breaker.Open the dishwasher door and remove the Torx screws holding the inner door panel to the outer panel.Separate the inner and outer door panels to expose the internal components.Carefully disconnect the ribbon cable that connects the keypad to the main control board.Remove the screws holding the old keypad and control panel assembly in place and remove it.Install the new control panel (Part #807545701), securing it with the screws.Reconnect the ribbon cable to the control board, reassemble the door panels, and restore power to test the new keypad.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dishwasher Focused repair path: dishwasher fill, drain, wash, heat, latch, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dishwasher repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dishwasher model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering.