Electrolux Dishwasher Error ER-07-OR-ER-11-3

How to Fix ER-07 OR ER-11 Error (Step-by-Step) Cut the power to the dishwasher from the fuse box.Place towels under the dishwasher to catch any water and confirm the error stays cleared during a full test cycle.The drain valve is located at the bottom of the dishwasher.Disconnect the hose and the electrical connector from the valve.Unfasten the old valve and install the new one and confirm the error stays cleared during a full test cycle.Reconnect the hose and electrical wires, then turn the power back on to test.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dishwasher Focused repair path: dishwasher fill, drain, wash, heat, latch, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dishwasher repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dishwasher model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering.