⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: EB4 Difficulty: Hard
Problem: Zero Watt relay alarm; low power supply voltage.
How to Fix EB4 Error (Step-by-Step)
- Unplug the washer from the power outlet and confirm the error stays cleared during a full test cycle.
- Use a multimeter to test the wall outlet to confirm it is providing the correct voltage (approximately 120V). Do not proceed if you are unsure how to do this safely.
- If the outlet is functional, remove the washer’s top panel to access the main control board.
- Visually inspect the power cord and its connection to the control board for any signs of damage, burns, or loose wires.
- If the wiring appears secure, the issue is internal to the main control board, which will require replacement.
- Disconnect all wiring from the old board and carefully transfer them to the new board.
- Reassemble the washer, plug it in, and test its functionality.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Verified Compatible Alternatives:
- 134994800
- 137363700
- 5304534274
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply