How to Fix Amana Dryer Error F8FC

Amana Dryer Error F8FC overlay image

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: F8FC Difficulty: Hard

Problem: Speech module power surge detected.

⚖️ Repair Decision
⚠️ CHECK WARRANTY / AGE

no_parts

How to Fix F8FC Error (Step-by-Step)

  1. Disconnect the dryer from the power source by unplugging it from the wall outlet. For gas dryers, also shut off the gas supply valve.
  2. Access the electronic control board. This is typically located behind the main console. You may need to remove screws from the top or back panel of the dryer to lift or remove it.
  3. Take a clear photo of the wire connections on the old control board before disconnecting anything. This will be your reference for connecting the new board.
  4. Carefully disconnect all wire harnesses from the old electronic control board. Most connectors have a small locking tab that needs to be pressed to release the plug.
  5. Remove the screws or release the clips holding the old control board in place and lift it out of the dryer.
  6. Install the new electronic control board, securing it with the same screws or clips. Reconnect all the wire harnesses by referring to the photo you took earlier, ensuring each plug is firmly seated in the correct socket.
  7. Reassemble the dryer’s console and any panels you removed. Plug the dryer back into the power outlet (and turn on the gas supply if applicable) and run a test cycle to ensure the error is cleared and the dryer functions correctly.
  8. Turn the appliance off, wait about 2 minutes, then turn it back on.
Parts Availability Note: For this Electrolux/Frigidaire error code, exact OEM part numbers can vary by model revision and serial range. We’ve listed the most likely component(s), but confirm compatibility using your full model number before ordering. If no exact SKU is shown, use this guide for diagnosis first, then verify the matching OEM part on RepairClinic or PartSelect.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

💬 Chat with a Certified Technician Now

Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)

⚡ Don’t Risk a DIY Fail!

Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.

✅ Join 15,000+ DIYers • Instant PDF Download


Browse More Codes

📖 View All Error Codes

Expert: Mike Sullivan

EPA Section 608 Certified Technician with 18+ years experience.

Read Editorial Standards →

Browse all Amana error codes: Amana Error Codes

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *