⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: F8E3 Difficulty: Moderate
Problem: Inlet thermistor error.
How to Fix F8E3 Error (Step-by-Step)
- Disconnect the dryer from the wall outlet to ensure your safety.
- You will likely need to remove the dryer’s rear panel by taking out the screws along its outer edge.
- Locate the inlet thermistor. It is a small, usually black or white, plastic sensor mounted on the housing of the blower wheel or heating element.
- Check the wire harness connected to the thermistor. Unplug it and plug it back in to make sure the connection is secure and free of corrosion.
- If the connection looks good, the thermistor itself has likely failed and needs to be replaced.
- Re-install the rear panel securely and confirm the error stays cleared during a full test cycle.
- Plug the dryer in and test it. If the problem persists, contact a service to test and replace the part.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Verified Compatible Alternatives:
- WP8577274
- WP31001590
- WP35001191
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply