⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: F# E# Difficulty: Easy
Problem: A general fault has been detected by the dryer’s control board that requires service.
How to Fix F# E# Error (Step-by-Step)
- Press the ‘Cancel’ or ‘Power’ button to attempt to clear the code.
- Unplug the dryer from the electrical outlet and confirm the error stays cleared during a full test cycle.
- Leave the dryer unplugged for at least 5 minutes to allow the control board to reset.
- Plug the dryer back in and try to start a new cycle.
- Before calling for service, check that the circuit breaker for the dryer has not tripped.
- If the code persists, the dryer’s electronic control system has detected a fault that requires professional diagnosis.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Amana error codes: Amana Error Codes
Leave a Reply