GE Refrigerator Error ER-T1-ER-T6-2

How to Fix ER T1 - ER T6 Error (Step-by-Step) First, unplug the refrigerator from the wall outlet to disconnect all power.Empty the contents of the affected compartment (refrigerator or freezer) and remove any shelves needed to access the interior back or side panel.The temperature sensor is usually located behind a small plastic cover. Unscrew or unclip this cover to expose the sensor.The sensor is a small plastic probe with a wire attached. Carefully disconnect the wire harness that connects the old sensor to the refrigerator.Connect the new temperature sensor (Part No. 240597203) to the wire harness.Snap the new sensor into its designated clip or housing and re-attach the protective cover.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Refrigerator Focused repair path: refrigerator door, airflow, sensor, defrost, dispenser, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux refrigerator repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux refrigerator model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. &tag=appliancefixg-20