GE Refrigerator Error ER-T1-ER-T6

How to Fix ER T1 - ER T6 Error (Step-by-Step) Unplug the refrigerator from the wall outlet to prevent electrical shock.Locate the temperature sensor (thermistor) inside the fresh food or freezer compartment. It is usually found clipped to the evaporator coils or housed in a small plastic casing on the wall.Disconnect the wire harness from the faulty sensor and confirm the error stays cleared during a full test cycle.If the sensor is attached with a screw, remove it. Otherwise, gently unclip it from its mounting position.Install the new temperature sensor (part 240597203) by connecting the wire harness and securing it in the same location as the old one.Ensure the sensor is positioned correctly for accurate temperature readings.Plug the refrigerator back in. The control board should now receive the correct temperature information, clearing the error code.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Refrigerator Focused repair path: refrigerator door, airflow, sensor, defrost, dispenser, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux refrigerator repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux refrigerator model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. &tag=appliancefixg-20