Error Code: ER-12 Difficulty: Hard
Problem: There is a drain valve position error.
How to Fix ER-12 Error (Step-by-Step)
- Shut off power to the dishwasher at the circuit breaker and turn off the water supply line, usually under the sink.
- Place towels under the dishwasher and remove the front kickplate to access the components.
- Locate the drain valve, which will have hoses and a wire connector attached.
- Disconnect the wire harness from the valve and confirm the error stays cleared during a full test cycle.
- Use pliers to loosen the clamps on the hoses connected to the valve and pull them off. Be prepared for some water to spill.
- Remove the old valve and install the new one, securing it in place.
- Reconnect the hoses and wire harness, turn the power and water back on, and run a cycle to check for leaks.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Verified Compatible Alternatives:
- 154663004
- 154750502
- 5304512731
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Browse all Electrolux error codes: Electrolux Error Codes
When It’s Better to Replace Than Repair
Sometimes replacing an appliance makes more financial sense than putting more money into repairs.
Here are a few signs it may be time to shop for a new one:
- ✓Appliance over 8-10 years old
- ✓Repair cost over 50% of replacement
- ✓Multiple recent breakdowns
- ✓Major component failure
Recommended Replacement Options
Why Upgrade via Amazon?
- Fast, Scheduled Delivery – You pick the date and time
- Expert Installation – Professional setup available for most models
- Old Appliance Haul-away – They’ll take your broken unit when they leave
- Easy Returns – Buy with confidence from a leader in customer service
As an Amazon Associate, we earn from qualifying purchases.
Leave a Reply