Error Code: F8 Difficulty: Hard
Problem: Water level sensor fault.
How to Fix F8 Error (Step-by-Step)
- Unplug the washer from the power outlet for safety and confirm the error stays cleared during a full test cycle.
- Turn off both the hot and cold water supplies to the washer.
- Locate the water level sensor, which is typically a small, round part with a tube and wires connected to it, often found behind the control panel or in the upper part of the washer cabinet.
- Carefully disconnect the wiring harness and the air tube from the old sensor.
- Remove the screws or clips holding the sensor in place and take it out.
- Install the new water level sensor, making sure to securely reattach the air tube and wiring harness.
- Reassemble the washer, turn the water back on, and plug the machine back in to test its operation.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Verified Compatible Alternatives:
- 5304505436
- 5304511335
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Browse all Electrolux error codes: Electrolux Error Codes
When It’s Better to Replace Than Repair
Sometimes replacing an appliance makes more financial sense than putting more money into repairs.
Here are a few signs it may be time to shop for a new one:
- ✓Appliance over 8-10 years old
- ✓Repair cost over 50% of replacement
- ✓Multiple recent breakdowns
- ✓Major component failure
Recommended Replacement Options
Why Upgrade via Amazon?
- Fast, Scheduled Delivery – You pick the date and time
- Expert Installation – Professional setup available for most models
- Old Appliance Haul-away – They’ll take your broken unit when they leave
- Easy Returns – Buy with confidence from a leader in customer service
As an Amazon Associate, we earn from qualifying purchases.
Leave a Reply