Error Code: EF4 Difficulty: Moderate
Problem: No flowmeter signal.
How to Fix EF4 Error (Step-by-Step)
- Shut off the water supply to the washer and unplug the appliance.
- The water inlet valve and flowmeter are located where the water hoses connect to the back of the washer. You may need to remove the top panel for better access.
- Disconnect the hoses from the inlet valve and confirm the error stays cleared during a full test cycle.
- Disconnect the wire harnesses from the solenoids on the valve and the flowmeter.
- Remove the screws holding the inlet valve assembly in place and remove it from the washer.
- Install the new water inlet valve and flowmeter assembly, securing it with the screws.
- Reconnect the hoses and wire harnesses, then turn on the water and power to test.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Verified Compatible Alternatives:
- 134371220
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Browse all Electrolux error codes: Electrolux Error Codes
When It’s Better to Replace Than Repair
Sometimes replacing an appliance makes more financial sense than putting more money into repairs.
Here are a few signs it may be time to shop for a new one:
- ✓Appliance over 8-10 years old
- ✓Repair cost over 50% of replacement
- ✓Multiple recent breakdowns
- ✓Major component failure
Recommended Replacement Options
Why Upgrade via Amazon?
- Fast, Scheduled Delivery – You pick the date and time
- Expert Installation – Professional setup available for most models
- Old Appliance Haul-away – They’ll take your broken unit when they leave
- Easy Returns – Buy with confidence from a leader in customer service
As an Amazon Associate, we earn from qualifying purchases.
Leave a Reply