Error Code: E97 Difficulty: Hard
Problem: Mismatch between the cycle selector and the main control board’s cycle data.
How to Fix E97 Error (Step-by-Step)
- Begin by unplugging the washer from the power outlet for safety.
- Open the detergent dispenser drawer and remove any screws located in the opening. Then, remove the top panel of the washer by unscrewing it from the back.
- This will give you access to the front control panel where the cycle selector (part 5304519503 or 809019903) is located.
- Take a picture of the wiring connections to the cycle selector module before proceeding.
- Disconnect the wire harnesses attached to the module. You may need to gently pry the locking tabs on the connectors.
- Remove the control knob and any screws holding the old cycle selector in place. Install the new selector.
- Reconnect the wiring, reassemble the control panel and top lid, and then restore power to the washer.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Verified Compatible Alternatives:
- 5304519503
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Browse all Electrolux error codes: Electrolux Error Codes
When It’s Better to Replace Than Repair
Sometimes replacing an appliance makes more financial sense than putting more money into repairs.
Here are a few signs it may be time to shop for a new one:
- ✓Appliance over 8-10 years old
- ✓Repair cost over 50% of replacement
- ✓Multiple recent breakdowns
- ✓Major component failure
Recommended Replacement Options
Why Upgrade via Amazon?
- Fast, Scheduled Delivery – You pick the date and time
- Expert Installation – Professional setup available for most models
- Old Appliance Haul-away – They’ll take your broken unit when they leave
- Easy Returns – Buy with confidence from a leader in customer service
As an Amazon Associate, we earn from qualifying purchases.
Leave a Reply