Electrolux Washer Error E71

How to Fix E71 Error (Step-by-Step) Disconnect the washer from the power source by unplugging it from the wall outlet. Turn off the water supply to the washer and confirm the error stays cleared during a full test cycle. Locate the temperature sensor, which is typically found near the heating element on the back of the wash tub. Disconnect the wiring harness from the sensor and confirm the error stays cleared during a full test cycle. Remove the old sensor by unscrewing it or releasing the clip that holds it in place. Install the new temperature sensor, ensuring it is securely fastened. Reconnect the wiring harness and restore the power and water supply to test the machine. Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Washer Focused repair path: washer fill, drain, spin, lock, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux washer repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux washer model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. Recommended Parts to Check No exact official OEM part number is listed here because the correct Electrolux washer part can vary by complete model number. These are targeted part-category searches, not universal fit claims. Electrolux washer drain pump Common replacement category: Drain pump Fit note: Exact OEM part number varies by complete Electrolux washer model number. Confirm compatibility before buying. Why this category can matter: drain, no-spin, or water-removal symptoms after hose and filter checks. Search Amazon for Electrolux washer drain pump Electrolux washer water inlet valve Common replacement category: Water inlet valve Fit note: Exact OEM part number varies by complete Electrolux washer model number. Confirm compatibility before buying. Why this category can matter: fill and slow-fill symptoms after supply checks. Search Amazon for Electrolux washer water inlet valve Electrolux washer door lock Common replacement category: Door lock / latch Fit note: Exact OEM part number varies by complete Electrolux washer model number. Confirm compatibility before buying. Why this category can matter: start, lock, or spin symptoms tied to door-lock feedback. Search Amazon for Electrolux washer door lock Before ordering: match the part to the complete Electrolux washer model number on the appliance tag. Still Not Working? If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure. Browse all Electrolux error codes: Electrolux Error Codes