Error Code: E49 Difficulty: Hard
Problem: Door is detected as open while the control board is trying to lock it.
How to Fix E49 Error (Step-by-Step)
- Unplug the washer from the power outlet and confirm the error stays cleared during a full test cycle.
- Open the door and first inspect the door strike and hinge for any signs of damage, looseness, or misalignment. Tighten any loose screws on the hinge.
- If the door alignment seems correct, the problem is likely the door lock assembly. Proceed to remove the outer spring clamp from the door boot seal.
- Peel back the rubber boot seal to access the screws for the door lock assembly.
- Remove the screws and pull the assembly out slightly and confirm the error stays cleared during a full test cycle.
- Disconnect the wire connector from the old lock and attach it to the new one.
- Reinstall the new lock assembly, reposition the boot seal, and secure it with the clamp before plugging the washer back in.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Verified Compatible Alternatives:
- 5304505088
- 5304514774
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Browse all Electrolux error codes: Electrolux Error Codes
When It’s Better to Replace Than Repair
Sometimes replacing an appliance makes more financial sense than putting more money into repairs.
Here are a few signs it may be time to shop for a new one:
- ✓Appliance over 8-10 years old
- ✓Repair cost over 50% of replacement
- ✓Multiple recent breakdowns
- ✓Major component failure
Recommended Replacement Options
Why Upgrade via Amazon?
- Fast, Scheduled Delivery – You pick the date and time
- Expert Installation – Professional setup available for most models
- Old Appliance Haul-away – They’ll take your broken unit when they leave
- Easy Returns – Buy with confidence from a leader in customer service
As an Amazon Associate, we earn from qualifying purchases.
Leave a Reply