How to Fix Electrolux Dryer Error E9E

Error Code: E9E Difficulty: Hard

Problem: Low voltage condition detected by the control board.

How to Fix E9E Error (Step-by-Step)

1. First, unplug the dryer from its power source. Then, check your home’s circuit breaker or fuse box to ensure the dryer’s circuit is not tripped and is supplying full power.
2. If the circuit is fine, remove the top panel of the dryer by unscrewing it from the back.
3. Locate the main control board. Visually inspect the board and its wire connections for any signs of damage, such as burn marks or loose wires.
4. Ensure the main power harness is securely connected to the control board.
5. If the power supply is good and connections are secure, the control board is likely faulty. Photograph the wire layout, then disconnect the harnesses and remove the board.
6. Install the new control board, making sure to connect all wires to their correct terminals based on your photo.
7. Reassemble the dryer, plug it in, and run a cycle to confirm the low voltage error is resolved.
8. Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Electrolux error codes: Electrolux Error Codes