⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.
Error Code: E35 Difficulty: Hard
Problem: The water level is too high.
How to Fix E35 Error (Step-by-Step)
- First, unplug the washing machine to prevent any electrical accidents.
- Locate the water inlet valve at the back of the machine where the water hoses connect. Inspect it to see if it’s stuck open, which can cause overfilling.
- Disconnect the water hoses and check the small filter screens inside the valve connections for debris; clean them if necessary.
- Access the pressure switch by removing the top panel. Check the air hose connected to it for blockages or damage.
- If the valve and hose seem okay, the pressure switch is the next part to check. It may not be correctly sensing the water level.
- Replace the pressure switch by disconnecting its wires and hose, removing the old part, and installing the new one.
- If the problem persists after replacing the pressure switch, the water inlet valve is likely faulty and needs to be replaced.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
Verified Compatible Alternatives:
- 134762000
- 134762010
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Most DIY parts are $50–$250. If you have a quote, use the total.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply