How to Fix Electrolux Washer Error E34

Error Code: E34 Difficulty: Hard

Problem: Incongruency between the electronic pressure switch and the anti-boiling pressure switch level for over 60 seconds.

How to Fix E34 Error (Step-by-Step)

1. Power down the washer completely by unplugging it from the wall socket.
2. Remove the necessary exterior panels to access the electronic pressure switch and the anti-boiling pressure switch.
3. Visually inspect the wiring and connectors for both switches. Ensure they are firmly attached and show no signs of damage or burning.
4. Check the air tubes connected to both switches for any obstructions, splits, or loose fittings. Clear any blockages you find.
5. Using a multimeter, you can test the continuity of each switch, but this is an advanced step. A simpler approach is to replace the primary electronic pressure switch first, as it’s a common failure point.
6. If replacing the first switch doesn’t solve the error, the anti-boiling switch may be the cause.
7. After replacing the part(s), carefully reassemble the washer and run a test cycle.
8. Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Electrolux error codes: Electrolux Error Codes