Error Code: E06 Difficulty: Moderate
Problem: Water level is too high at the end of a program.
How to Fix E06 Error (Step-by-Step)
- Disconnect the washer from the power source and confirm the error stays cleared during a full test cycle.
- Locate the water level pressure switch. It’s usually a round component with a thin air tube and a wire connector, located in the upper section of the machine.
- Carefully disconnect the rubber or plastic air tube from the switch.
- Inspect the tube for any signs of blockages, kinks, or holes. Blow through the tube towards the tub to ensure it is clear of any debris or suds buildup.
- If the tube is clear, the pressure switch itself may be faulty. Disconnect the wiring harness and remove the switch.
- Install the new pressure switch, securely reattaching the air tube and the electrical connector.
- Reassemble the washer, plug it back in, and run a test cycle to check for proper water level control.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Verified Compatible Alternatives:
- 137055800
- 5304505436
- 5304511335
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Browse all Electrolux error codes: Electrolux Error Codes
When It’s Better to Replace Than Repair
Sometimes replacing an appliance makes more financial sense than putting more money into repairs.
Here are a few signs it may be time to shop for a new one:
- ✓Appliance over 8-10 years old
- ✓Repair cost over 50% of replacement
- ✓Multiple recent breakdowns
- ✓Major component failure
Recommended Replacement Options
Why Upgrade via Amazon?
- Fast, Scheduled Delivery – You pick the date and time
- Expert Installation – Professional setup available for most models
- Old Appliance Haul-away – They’ll take your broken unit when they leave
- Easy Returns – Buy with confidence from a leader in customer service
As an Amazon Associate, we earn from qualifying purchases.
Leave a Reply