Error Code: C8 Difficulty: Hard
Problem: Temperature sensor problem.
How to Fix C8 Error (Step-by-Step)
- Ensure your safety by unplugging the washer from the electrical outlet and turning off both the hot and cold water supply valves.
- Depending on your model, you will need to access the rear of the machine. Remove the screws holding the rear access panel in place and set the panel aside.
- Look for the heating element, which is a metal component near the bottom of the washtub. The temperature sensor, a small plastic probe with wires, is mounted directly on this heating element.
- Carefully disconnect the wire harness attached to the sensor. There may be a small clip you need to press to release the connector.
- The sensor is typically held in place by a locking tab or a snug rubber grommet. Gently pry the old sensor out of its mounting hole on the heating element.
- Firmly press the new temperature sensor into the empty slot until it is securely seated. Reconnect the wire harness, ensuring it clicks into place.
- Reattach the rear access panel with its screws. Turn the water supply back on, plug the washer in, and run a test cycle to confirm the C8 error is gone.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Parts to Check
No exact official OEM part number is listed here because the correct Electrolux washer part can vary by complete model number. These are targeted part-category searches, not universal fit claims.
-
Electrolux washer drain pumpCommon replacement category: Drain pumpFit note: Exact OEM part number varies by complete Electrolux washer model number. Confirm compatibility before buying.Why this category can matter: drain, no-spin, or water-removal symptoms after hose and filter checks.
-
Electrolux washer water inlet valveCommon replacement category: Water inlet valveFit note: Exact OEM part number varies by complete Electrolux washer model number. Confirm compatibility before buying.Why this category can matter: fill and slow-fill symptoms after supply checks.
-
Electrolux washer door lockCommon replacement category: Door lock / latchFit note: Exact OEM part number varies by complete Electrolux washer model number. Confirm compatibility before buying.Why this category can matter: start, lock, or spin symptoms tied to door-lock feedback.
Before ordering: match the part to the complete Electrolux washer model number on the appliance tag.
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Browse all Electrolux error codes: Electrolux Error Codes
When It’s Better to Replace Than Repair
Sometimes replacing an appliance makes more financial sense than putting more money into repairs.
Here are a few signs it may be time to shop for a new one:
For repair parts, verify exact fit with the full washer model number before buying; these links are general replacement-appliance shopping options.
- ✓Appliance over 8-10 years old
- ✓Repair cost over 50% of replacement
- ✓Multiple recent breakdowns
- ✓Major component failure
Recommended Replacement Options
Why Upgrade via Amazon?
- Fast, Scheduled Delivery – You pick the date and time
- Expert Installation – Professional setup available for most models
- Old Appliance Haul-away – They’ll take your broken unit when they leave
- Easy Returns – Buy with confidence from a leader in customer service
As an Amazon Associate, we earn from qualifying purchases.
Leave a Reply