Electrolux Dryer Error E58

How to Fix E58 Error (Step-by-Step) Disconnect the dryer from the power outlet and confirm the error stays cleared during a full test cycle.Access the motor and the inverter board by removing the dryer's service panels.Examine the wires connecting the motor to the inverter board for any damage.If the wires are intact, the issue is likely with the motor or the inverter board.Test the motor windings with a multimeter to see if they are shorted.If the motor tests fine, the inverter board is the most likely cause of the problem and should be replaced.After replacing the faulty component, reassemble the dryer and plug it back in.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Electrolux Dryer Focused repair path: dryer airflow, heating, motor, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test. Disconnect power before opening panels, then confirm whether the Electrolux dryer repeats the same code after a clean reset. Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response. Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage. Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure. Use the complete Electrolux dryer model number from the appliance tag before ordering any model-specific part. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering. &tag=appliancefixg-20Verified Compatible Alternatives:134735700137099100137261100