Error Code: C8 Difficulty: Moderate
Problem: Indicates a problem with the temperature sensor.
How to Fix C8 Error (Step-by-Step)
- Ensure the dryer is unplugged from the power outlet and confirm the error stays cleared during a full test cycle.
- Locate the temperature sensor (thermistor). It is usually found on the blower housing or the heater duct at the rear of the dryer. You will likely need to remove the rear panel.
- Disconnect the two wires attached to the sensor. The connector can be pulled straight off.
- Remove the screw that holds the temperature sensor in place and remove the old sensor.
- Install the new temperature sensor and secure it with the screw.
- Reconnect the wire connector to the new sensor and confirm the error stays cleared during a full test cycle.
- Replace the rear panel, plug the dryer in, and test it by starting a new cycle.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
What to Check Next on This Electrolux Dryer
Focused repair path: dryer airflow, heating, motor, sensor, and control checks. Do not treat the fault as reset-only if it keeps returning; use the failed function to choose the next test.
- Disconnect power before opening panels, then confirm whether the Electrolux dryer repeats the same code after a clean reset.
- Match the symptom to the part of the cycle or function that fails: fill, drain, heat, cool, spin, latch, ignite, fan, sensor, or control response.
- Inspect simple causes first: airflow, water supply, drain path, door closure, filter, venting, wiring connectors, and visible damage.
- Use meter testing or service diagnostics before replacing electronic controls, because wiring, switches, sensors, and loads can mimic board failure.
- Use the complete Electrolux dryer model number from the appliance tag before ordering any model-specific part.
Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Electrolux model number from the appliance tag before ordering.
Recommended Replacement Part
When It’s Better to Replace Than Repair
Dryer repairs are often worth it for small parts, but repeated heating, motor, drum, or control failures can point toward replacement.
Confirm gas vs electric, venting, voltage, doorway clearance, and laundry-space dimensions before ordering.
For repair parts, verify exact fit with the full dryer model number before buying; these links are general replacement-appliance shopping options.
- [OK]Thermal fuse or heater failures keep returning
- [OK]Belt, roller, or motor repairs exceed unit value
- [OK]Door switch or control issues stack with other faults
- [OK]Older dryer has long dry times even after vent cleaning
Recommended Dryer Replacement Options
As an Amazon Associate, we earn from qualifying purchases.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Electrolux model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Electrolux error codes: Electrolux Error Codes
Leave a Reply