Error Code: F3E1 Difficulty: Easy
Problem: Pressure system fault.
How to Fix F3E1 Error (Step-by-Step)
- Cancel any active cycle and power off the dishwasher and confirm the error stays cleared during a full test cycle.
- Open the door and pull the bottom dish rack completely out.
- Find the dishwasher filter, usually located in the back corner of the tub floor. Twist it counter-clockwise to unlock and lift it out.
- Wash the filter screen and the coarse filter plate under warm running water. Use a soft brush to gently scrub away any stuck-on food particles.
- Look into the filter housing in the dishwasher tub and carefully remove any debris you see.
- Place the clean filter back into its housing and twist it clockwise until it locks firmly in place.
- Run a quick rinse cycle to confirm the error is cleared.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
Browse all Amana error codes: Amana Error Codes
When It’s Better to Replace Than Repair
Sometimes replacing an appliance makes more financial sense than putting more money into repairs.
Here are a few signs it may be time to shop for a new one:
- ✓Appliance over 8-10 years old
- ✓Repair cost over 50% of replacement
- ✓Multiple recent breakdowns
- ✓Major component failure
Recommended Replacement Options
Why Upgrade via Amazon?
- Fast, Scheduled Delivery – You pick the date and time
- Expert Installation – Professional setup available for most models
- Old Appliance Haul-away – They’ll take your broken unit when they leave
- Easy Returns – Buy with confidence from a leader in customer service
As an Amazon Associate, we earn from qualifying purchases.
Leave a Reply