Amana Dryer Error F23-2

How to Fix F23 Error (Step-by-Step) Ensure the dryer is completely unplugged from the power source.Remove the screws from the back of the dryer that hold the top panel in place, then slide the panel off.Remove the control panel console by taking out its mounting screws.Open the dryer door and remove the screws located inside the door frame that secure the front panel.Carefully lean the front panel forward, locate the thermistor on the blower housing, and disconnect its wire harness.Use a screwdriver to remove the single screw mounting the thermistor to the housing and remove the old part.Secure the new thermistor with the screw, plug in the wire harness, and reassemble the front panel, control console, and top panel.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Amana Dryer Focused repair path: dryer airflow, heating, sensor, motor, door switch, belt, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check. Disconnect power before inspection, then clear the lint screen, blower area, vent run, and exterior hood before replacing heat parts. Confirm whether the dryer starts, tumbles, heats, and advances through the cycle; the missing function narrows the repair path. For heat faults, inspect airflow first, then the thermal fuse, thermistor, element or gas ignition path, wiring, and control output. For start or tumble faults, check the door switch, belt switch, motor circuit, harness, and control connections before ordering parts. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model. &tag=appliancefixg-20