Amana Dryer Error 2

How to Fix -:-- Error (Step-by-Step) Unplug the dryer from the electrical outlet or turn it off at the circuit breaker.Wait for 5 minutes to allow the internal electronics to fully discharge and reset.Plug the dryer back in or switch the circuit breaker on.Attempt to start a normal drying cycle to see if the code has been cleared.If the dashes reappear on the display, this indicates a more serious issue with the main control board.Due to the complexity and risk of working with electronic components, replacement of the control board should be performed by a qualified appliance service.Turn the appliance off, wait about 2 minutes, then turn it back on.

What to Check Next on This Amana Dryer Focused repair path: dryer airflow, heating, sensor, motor, door switch, belt, and control checks. Do not treat a returning fault as a reset-only problem; use the point in the cycle where the fault appears to choose the next check. Disconnect power before inspection, then clear the lint screen, blower area, vent run, and exterior hood before replacing heat parts. Confirm whether the dryer starts, tumbles, heats, and advances through the cycle; the missing function narrows the repair path. For heat faults, inspect airflow first, then the thermal fuse, thermistor, element or gas ignition path, wiring, and control output. For start or tumble faults, check the door switch, belt switch, motor circuit, harness, and control connections before ordering parts. Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Amana model number from the appliance tag before ordering. Similar error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, fans, or control boards depending on the exact model. &tag=appliancefixg-20